Sequential gear display

This gear indicator has been designed specifically for use with our shifters. Our testing showed that the simple 7 segment led display give the best visibility without distracting the driver.

The gear indicator is mounted in its own 44mm aluminum housing finished in a sandblasted and anodised finish.

We have integrated a light sensor to minimize wiring and make sure the brightness is perfect in all conditions.

The recent 2020 update allows the reverse input to be either a positive or ground trigger and the small style have 360 degree code for easy installation without orientating the sensor.

Gear position sensor to suit our sequential shifters.

** These sensors will not work with gear indicators sold before July 2022, those sensors clipped the signal by about 0.5V at each end. The current sensors go all the way from 0- supply voltage in output , We can no longer supply the earlier version due to the chip shortage **

This sensor uses a modern hall effect it needs a 5v supply and will output a voltage between 0-5v depending on the position of the magnet inside the shifter. This magnet was factory fitted.

You cannot read the position of the sensor with resistance on a multimeter you will need to use the voltage setting with a 5v supply connected to the sensor.

Wiring colours are :

White/blue or Green  = Ground

White/Yellow or orange = 5V supply in

White/White = Signal out

Any voltage over 5.5 V will break the sensor.